Hello,
I have just received Pack 3 for the HMS Victory build which included the free tool set. Included is a pin push for use with all the planking which makes up pack 3. Each set of planks has a small bag of brass pins and the pinheads of only about 1 in 10 actually fits inside the pin push! Have I just been unlucky or has anyone else experienced this problem? I suspect the problem is in the manufacturing of the pins. Has anyone sourced alternative pins that actually fit and if so, from where. I have has a look on-line and it appears there are a number of sizes - not sure which I will need. I did ring customer support but I don't think the problem was fully understood!
Any help will be apprecited.
I didn't find the right solution from the Internet.
References:
http://forum.model-space.co.uk/default.aspx?g=posts&t=24994
Thank you.